a couple of home owners hard at work painting their living room wall green

Painting Your Home, Three Secrets You Don’t Know

When it comes time to paint your home you’ll recognize that there is a lot to know, all it takes is a quick visit to your neighbourhood paint store many of which you can find on the web, or a few minutes searching the web to come across a significant number of professional painting forums to uncover some significant secrets and tricks of the trade. There are quite a number of painting secrets that pros know and DIY painters don’t know, in fact the biggest difference between a pro and DIY painter is the accumulation of these secrets and also a healthy dose of experience. Which leads us to our first secret.

Clean Lines With Standard Painters Tape

We’ve all tried to use painters tape with mixed success, often times the normal green painters tape only works if you are basically dry brushing on top of the tape, but did you know that there is a better way?

If you want normal painting tape to give you a sharp finish after you peel it off you should apply the tape, rub it with a rag, then apply a very dilute water and caulking solution to the edge? Once this dries and you paint over it the caulk and water solution will seal the edge of the tape allowing you to get a remarkably clean and straight line after the tape has been removed. Anyhow, so that’s just one secret about house painting you likely do not know about that’ll make your paint lines clean and straight.

painting a wall using a roller

Clean Before You Paint

Another potential secret is to make sure that you clean before you paint. This can be a problem especially when painting in cramped spots with a paint brush, which is common during a cut-in or some external painting jobs.

Rather than fully cleaning these hard to reach, hard to see spots, one trick is to carry an old paint brush or simply pick one up from the dollar store. Use the brush to dust the spots you’ll be painting before you apply the paint, sinc the brush is cheap and/or old don’t be afraid to clean the spot vigorously since you’ll want to have a nice surface before you apply your coat of paint.

Always bear in mind that fully preparing the surface before you paint is a good idea and that this technique should be applied sparingly, but it can save you quite a few trips up and down a ladder depending on where you put it to use.

Choose Your Primer Wisely

This is a quick and dirty secret. When spot priming your walls, for instance after patching holes, it’s always advisable to prime the surface before you do the finishing coat. It is recommended even on patching compounds that suggest you do not need to prime them, the reasons is that the surface of the patching compound is going to be much more porous compared to the surrounding substrate, and this will show up on your finished wall. But, what primer do you use? Always initially use the cheapest primer you can find for this task, sometimes the surrounding surface was not fully primed and using expensive primers can result in one patch of the wall that is properly sealed resulting in a final coat that has some spots which have a higher sheen than the surrounding wall.

And if you’re still concerned, here’s a video with some more information:

There you have it, three secrets most DIY painters will know nothing about, I hope that it helps you on your journey to a fantastic paint job this summer.

Leave a Reply

Your email address will not be published. Required fields are marked *

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>